Surface Prep: Repairing
- Cracked or Peeling Paint
Remove any loose, peeling paint with a paint scraper and sandpaper. Sand all edges to smooth the surface and help the new paint adhere. Scrub all surfaces with a mild detergent with a sponge or rag to remove all dirt, grease, oil, etc. Rinse surface well and allow to dry. Spot-priming will help the new paint adhere and give a better finished look.
- Holes and Cracks
Small Cracks and Nail Holes - Brush the area clean. Use your finger or a putty knife to fill nail holes or very small cracks with wood filler if you are patching wood. For wood use a wood filler. For plaster and drywall use a non-shrinking or joint or spackling compound. Using a putty knife, apply a thin skin of filler over the patched area. After patch is dry, sand it smooth. Wipe with a moist cloth to remove dust, then spot-prime to create a uniform surface and help the new paint adhere.
Larger Holes and Cracks - For a holes and cracks larger than a nail hole, cut two pieces of a self-adhesive mesh joint tape, making sure that the pieces are larger than the hole. Center the two pieces in the shape of an "X" over the hole and press firmly into place. Cracks usually require just a single piece. Then, using a putty knife, cover the mesh with one or more layers of joint compound. When the material is dry, sand smooth and spot-prime.
- Removing Wallpaper
Start by using a scoring tool to create holes in the paper. Then use a paste remover or power steamer to re-wet the paste behind the paper. Use a scraper to remove loose wallpaper. After wallpaper is removed, wash the wall with a paste remover to remove any leftover sizing or paste. For any stubborn patches of paste, try a bristle brush or a mesh scrubber. Once the paper and paste are off, prime the bare walls. An oil-based primer is preferred over a latex-based primer becuase it prevents any remaining paste from bleeding through the finished coat. An oil primer is also the best choice if the wallpaper is on so firmly, you can't get it off.
- Sags, Drips, Runs
Sand to smooth sags, drips or runs. Use a damp, lint-free cloth to remove sanding dust.
- Water and Smoke Damage
After the cause of the damage has been corrected, use a primer-sealer designed for stain blocking. Before you begin priming, do a water test on an area of the ceiling that's not damaged. Apply water with a spray bottle. If the water beads, spot prime the damaged area only. If the water absorbs, you'll want to prime the entire ceiling. Read the product label to make sure the primer is recommended for your type of stain. Stain-blocking primers are available in both alkyd and latex-based versions. While both work to block this type of stain, the alkyd stain blocker will usually seal water stains better because it doesn't contain water that could re-wet the stain. You may still see the stain through the stain blocker, but they are designed to "lock-in" the stain to prevent it from bleeding through into the topcoat. Make sure the primer is thoroughly dry before you apply the topcoat.